Contact Us 619-729-6038

Most Important Drywall Tools

  Drywall Tools

In addition to your basic utility knife, you’ll need some special tools for cutting drywall sheets.

For making square cuts, use a drywall T-square.

Set your sheets of drywall upright with the smooth side out.

Set the T-square on the top edge and line it up with your measurement.

Run a utility knife along the side of the “T” to score your cut.

Snap the sheet back to break the sheet along the cut.

Then cut the paper back with a utility knife.

For making cuts around obstacles you can use a drywall saw.

Just use a back-and-forth motion like you would for any hand saw.

Cutting your sheets slightly too big is better than too small.

You can always shave the ends off with a rasp.

For cutting around electrical boxes use a keyhole saw.

Just punch the tip through the drywall and cut along each side.

You can also use a power jig saw for these cuts.

Circle CutterFor round cuts, like around light fixture boxes, use a circle cutter.

Find the center of your circle and punch in the center marker.

Adjust the arm to the radius of your circle and use it to score the perimeter of the circle.

Do the same on the other side of the sheet.

Tap out the cut out with a hammer.

You can also use a compass to draw the circles, and a keyhole saw to cut them.

There’s also a power tool professionals use that’s designed specifically for cutting out holes for electrical boxes and fixtures.

It’s like a drywall router, and they use it to cut the holes after the sheets of drywall are up.

This is a lot faster then cutting them all by hand.

If you do end up renting one of these power routers be careful so you don’t strip the electrical wiring inside.

Fastening Tools

For nailing up sheets of drywall, a drywall hammer is a must.

It has a convex head that creates a little dimple around the nail head without breaking the paper on the surface of the drywall.

This will allow you to cover the nail head with drywall mud and get a perfectly smooth surface.

Using drywall screws can go a lot faster, if you have the right tool.

You want to use a special electric drywall screw gun that lets you adjust it to sink the screws a little below the surface, again, so you don’t break the paper.

With a regular screw gun you don’t have this control.

Finishing Tools

The “art” of taping comes from using different sized taping knives to get a smooth, tapered joint.

For the first “tape coat” you’ll need a taping knife that’s 5″ or 6″ wide.

With each of the next two coats you’ll want to cover an inch or two farther in
each direction so you’ll probably need an 8″ to 10″ knife and a 12″ to 14″ knife.

Use a mud pan to hold the mud as you tape the joints.

For sanding the joints, use either a pole sander for dry sanding, or a wet sanding pad.

For applying texture to ceilings you’ll want to rent a sprayer specifically designed for this job.

( HomeTime )

Leave a Reply

Your email address will not be published. Required fields are marked *